Print This Page

Steps to Safety: Guide for Restarting Boilers After Summer Lay-Up

Print Date: 7/22/2024 11:30:56 PM

Robert Ferrell
Senior Staff Engineer
National Board

Category : Operations

Summary: This article was originally published in the Fall 2010 National Board BULLETIN.

Remember – the entire system must be carefully checked and operating procedures reviewed before the boiler is placed in operation. Boiler operators and other responsible personnel, such as supervisors, must be up to date on current codes and procedures.

It’s that time of year when heating boilers should be prepared for the heating season.

Before moving the boiler power switch to the ON position, survey the scene. I’ve taken that command from my first aid training. It means, “Before rushing in to help a victim, ensure you’re not the second victim.” Survey for potential hazards created by an improperly operating boiler or improperly stored material in the boiler room.

Your survey should ask the following questions: “What is the condition of the boiler system,” and “Has any work been performed on or near the boiler during the summer shutdown?”

If work has been done on or near the boiler, perform a system inspection tracing fuel lines, feed lines, steam and blow off piping, stack, and regulator vent lines. Check controls and control panels for evidence of damage and changes or loose connections. Inspect mechanical assemblies such as burner linkage and safety valve springs for paint, dirt, and rust accumulation which wouldn’t allow easy movement. Check all ventilation and combustion air openings are clean and free from debris.

Review the Manufacturer's Operation, Maintenance, and Instruction Manual for operation instructions. Become familiar with the timing sequence of the automatic controls. Then do a start-up check.

Start the boiler by moving the power switch to ON. Reset all manual reset switches, low water fuel cutoff (LWFC), fuel pressure switches, and pressure or temperature limits switches. Observe the start-up sequence. It may be necessary to isolate the boiler from the system to warm it up slowly.

Verify the flame conditions in the combustion chamber.

On gas fired non-condensing boilers, a cold start may produce condensate leaking from the gas pass covers and casing. Once the boiler water temperature exceeds 150° F, the condensate should stop.

Once the unit has warmed, turn power switch to OFF. Verify the shut down cycle. Then restart. Let it come up to full firing rate and open isolation/ stop valves to put it into the system. Monitor it throughout the day, looking at the flame, stack outlet, controls, and linkage. Verify gasket tightness for both water side and fire side.

If any abnormal condition occurs during start-up, turn the power switch to OFF. Investigate cause before restarting the boiler.